cast iron material farm irrigation mixed flow pump
Performance Range:
a)Capacities: (Q )up to 7000m3/h
b)Heads: (H )up to 25m
c)Operating pressure: (P) up to 0.6Mpa
d)Operating temperature: -20degrees to +120degrees.
Pump Overview
HW Series volute clean water irrigation pump is according to the national standard latest series
designed , with high efficiency energy saving features , its performance indicators are achieved
international advanced level, especially for material remarkable energy saving.
Driving mode: HW mixed flow pump can be used diesel engine, motor drive, its transmission
ways depending on the regions power up.
Pump features
1)HW pump combines the pump cover, impeller, shaft, bushings and bearings and other major
components.
2) Pump cover connects to pump and inlet respectively. There should be adequate clearance
between plane and the impeller pump cover. Actual appropriate clearance is 0.3 ~ 0.7mm (
the shaft into the pump inlet), the gap can be adjusted by changing the paper pad thickness.
3) Seal device consists of packing, packing gland, packing ring, and pump the fill ring. Its role is
to prevent air suction pump and prevent excessive water flow out from pump along the axial.
4)Axil sleeve is to protect the shaft. Timely replacement after worn.
5) Simple, reliable, easy fitting, and high efficiency, small size and light weight. Applies to trans-
port water or other liquids physical and chemical properties similar to water. Temperature
of transmission fluid is nothigher than 50 C.
HW Pump photos
Welcome contact us for more details.
We will reply you within 12 hours.