submersible water pump with stirring cutting system
Specifications
submersible sewage pumps
1, Power cable: standard cord is 10m
2, Liquid Temperature: 40°c continuous
3, Motor: class B insulation, IP68 protection
4, Single Phase: Built-in thermal protector
5, Accessories: Float switch is available
Materials
Pump casing: Plastic
Impeller: stainless steel vortex
Double-sided Mechanical Seal: Burna-N elastomers
Motor side Mechanical Seal:carbon VS silicon carbide
Pump side mechanical seal: silicon carbide VS silicon carbide
Shaft:45# steel or stainless steel
Bearing:SKF/NTN/China
LIMITS OF USE
8Maximum operating depth 5m below waterlevel
8Maximum fluid temperature 40°C
8PH value in water :4-10
8 Maximum Passage for suspended solids: 42mm
8 Protection:IP68
General Characteristics
* Impeller with a grinder system
* Grinder system contain a revolving cutter and a plate withholes, sharpened edges that fine-chops filaments, preventing fouling of the impeller.
They're designed to a wide tunnel which helps to convey the long fiber liquid or the solid whose diameter is about 25-42mm. The selection of bottom suction structure,stainless steel and special cast iron made the pump have the capabilities of complete drain and high resistance of abrasion and corrosion. The float switch and automatically control on and off with the change of the liquid lever. The protector in the motor can automatically cut off the power when it overheaded or overcurrented,thus guarantee the security and reliablity of pump's run even in the atroclous environment.
Performance Curve
Performance Table
DIAGRAM
