water purification system high quality frp ro membrane 8040
Product Description
BW-8040 Industrial Water Treatment Systems,Industrial Ro Water Purifier,Industrial Water Treatment Plant
(Suit for :Industial Factoy,Water Supply plant,Waste water treatment plant,Food or Drinking plant,ect , ask high water Permeate flow project).
BW series is mainly applicable to brackish water desalination, and enjoys the characteristics of low-pressure operation, high permeate flow and excellent desalination property. Furthermore, with the excellent property of eliminating the soluble salts, TOC and SiO2, it is especially suitable for the preparation of high-purity water in electronic and electricity industries.
Specifications:
RO Membrane Element
1-Membrane sheet's technology import from USA
2-Membrane sheet and element are produce at our factory with reliable quality .
3-reasonable price
4-flexible service
| Technical information | ||
| Type | BW-8040 | |
| Performance | Average rejection rate | 99.50% |
| Min. Salt rejection | 99.00% | |
| Average Permeate flow GPD(m3/d) | 10500(39.7) | |
| Testing condition | Active membrane area ft2(m2) | 400(37.2) |
| Testing pressure | 225psi(1.55Mpa) | |
| Temperature of testing solution | 25°C | |
| PH rate of testing solution | 7.5-8 | |
| Recovery rate of single membrane elements | 15% | |
| Concentration of testing solution(NaCl) 2000ppm | ||
How to use
Installation:
After preparing some glycerin, fixed tools, gloves and other protective equipment, please rinse and clean the pre-treatment (such as quartz sand filter and activated carbon filter) SDI15<5
Then, check whether there is no sludge, oil or any metal debris in the upstream pipes of Reverse Osmosis. Flush and clean the upstream pipes, the pressure vessels and the high pressure pipes.
Tear off the packing bag and do not move the trademarks and the blue package. Smear a small amount of lubricant at the part of the sealing ring. The end with two small seal rings head into the shell. Screw on the lid and fasten it. Connect the pipe.
Storage:
1/ Of Uninstalled modules
The modules should be stored in wetting conditions. Please, do not pierce the plastic bags in case of the opening and the checking of the quantity, and store it until its use.
Storage in a ventilated area and protected from direct sunlight with an ambient temperature of 10°C is recommended. The ambient temperature should be under 35°C.
Freezing will damage the performance of the module and its construction, insulation measures should be taken to prevent it.
2/ Of modules installed on a skid
The modules installed should be storaged in a gloom place with a temperature under 35°C, and protected from direct sunlight.
Please, take freezing prevention measures with a temperature under 0°C. Chemicals and flushing should be done regularly after the membrane running sometim
Advantages
